Day 5 of Geekmas - D&D Sword Dice Holder
On the 5th day of Geekmas, I printed this Sword Dice Holder from D&D. There was little to no post processing on this one. It just needed to be assembled, and little bit of gloop. This print is a nice break from the other prints of Geekmas as it's relatively easy to print with a high satisfaction upside. My only recommendation on this one would be to use tree supports on the blade.
You can see this one over on TikTok:
@geekyinc Day 5 of Geekmas brings us this legendary D&D short sword! Comment below if you'd like the link to print. #geekmas #geek #geekculture #dungeonsanddragons #shortsword
♬ original sound - geekyinc
The breakdown:
💡
Geeky Inc Category - Tabletop Gaming and Gaming
Original Appearance - Dungeons and Dragons
Time to Print (on a Bambu P1P) ~ 8 hours
Post Processing - Minor
Link to STL - https://www.printables.com/model/76474-freds-dice-dagger
Original Appearance - Dungeons and Dragons
Time to Print (on a Bambu P1P) ~ 8 hours
Post Processing - Minor
Link to STL - https://www.printables.com/model/76474-freds-dice-dagger